Anyone expericend with HRV or ERV? | Construction and DIY projects | Forums

A A A
Avatar
Search

— Forum Scope —






— Match —





— Forum Options —





Minimum search word length is 3 characters - maximum search word length is 84 characters

Lost password?
sp_Feed F-Construction-and-DIY
Anyone expericend with HRV or ERV?
Avatar
Gravel Road
Rancher
Members
Forum Posts: 1455
Member Since:
6 Oct ’15
sp_UserOfflineSmall Offline
1
19 Feb ’16 - 8:34 am
sp_Permalink sp_Print

Been researching HRV's and ERV's for the new place.  Air exchange is a concern with building 'tight', and if we go with the spray foam upstairs it is even more important to be aware of air exchanges.

I know some people advocate for earth tubes.  I don't see us going that way, the cost of material and trenching for us would be a lot more $$ than a HRV that I can install.

Being that we are building with very open floor plan and only 1 Bed Room and 1 Bath we only need a small system.

Most everything I have read says that a HRV is appropriate for the colder Northern Climate.

The HRV units are about $600 to $1,100 (the ones I am looking at least).  They are pretty simple to install in a new build.  Nice.

Thinking this would be money well spent to keep the house 'healthy'

I need to do some research though on building my own set up though.  I think I could build one that is more tailored to my set up and needs (important since we are not building very conventional).  There are some nice 'fans' to move air in and out that are good prices...could be set up with a simple timer that turns it on and off depending on the needs of the house. The duct work and the vents would be the same regardless...and the fans/timer/etc, are much less expensive, even when I add  in a simple filter set up...this makes it cost effective.

Any thoughts or knowledge on this folks???

http://www.ecohome.n.....en-hrv-erv

http://www.greenhome.....lator.html

"The universe is wider than our views of it." -HDT
Avatar
K
Admin
Forum Posts: 31782
Member Since:
15 Feb ’12
sp_UserOfflineSmall Offline
2
19 Feb ’16 - 9:07 am
sp_Permalink sp_Print

that's a lot cheaper than I thought, we just ran a 3 inch pipe in an outside wall through our inside wall and stubbed it out at ground level inside the house.

and just trimmed the wainscoting around it

you hardly notice it with the stain on 

I wonder if adding another one with a simple cpu fan on each, one inlet, one outlet would be sufficient 

Avatar
Gravel Road
Rancher
Members
Forum Posts: 1455
Member Since:
6 Oct ’15
sp_UserOfflineSmall Offline
3
19 Feb ’16 - 11:15 am
sp_Permalink sp_Print sp_EditHistory

yup...we have a dedicated 'pipe' for a supply to come up under the stove for combustion. 

We are thinking more about the overall 'air quality' related to whole house air exchanges.  I know we could crack a few windows...but this is one thing I am willing to automate a bit.

...are you thinking we don't need to be so concerned about it...I admit, I may be over thinking this 'need'.

 

(separately, looking at your open framing pic, did you run all 12 ga wire or 14?)

"The universe is wider than our views of it." -HDT
Avatar
K
Admin
Forum Posts: 31782
Member Since:
15 Feb ’12
sp_UserOfflineSmall Offline
4
19 Feb ’16 - 11:56 am
sp_Permalink sp_Print

I think so, could just rough it in for now and see how it goes the first year and add if needed

12 except for the smoke detectors are 14

Forum Timezone: America/New_York

Most Users Ever Online: 698

Currently Online:
67 Guest(s)

Currently Browsing this Page:
1 Guest(s)

Top Posters:

easytapper: 2149

DangerDuke: 2030

groinkick: 1667

PorkChopsMmm: 1515

Gravel Road: 1455

Newest Members:

Forum Stats:

Groups: 1

Forums: 12

Topics: 11482

Posts: 58640

 

Member Stats:

Guest Posters: 2

Members: 19842

Moderators: 0

Admins: 1

Administrators: K