Log In
Home
21 Feb ’12
Offline
It is a Felder 610, in single phase.
The power feeder is pneumatic and should arrive in the next month. Needed this for resawing book-matched wood for musical instruments. Tone woods like Rosewood, Pacific Big Leaf Maple, Mahogany etc.
Plus I wanted to start playing with veneers again.
Wanted something bigger (only 4 hp, 20 would be better) and in three phase but still sharing a shop I helped build this past year with a old friend.
Getting close to finishing a 3-4 compartment kiln inside a Grumman van then it is putting together a 50" throat wood mill. With a 30' table and 20 tonnes of hydraulics.
21 Feb ’12
Offline
Try this again.
I have been making cutting boards for a few folks but they have not been testing the finishes for me. Make these out of off cuts which do not make the grade for tone wood.
Picture is a little wonky.
27 Aug ’14
Offline
Hessian they look great! What are you using to finish them? I've used both mineral oil and beeswax on ours here at home but have never done a side by side.
21 Feb ’12
Offline
This one was three coats of a product called Watco Butcher Block Oil and Finish
Not very happy with it as it scratches pretty easily.
27 Aug ’14
Offline
Hmm, the "Poison" part would worry me as well.
Most Users Ever Online: 698
Currently Online:
50 Guest(s)
Currently Browsing this Page:
1 Guest(s)
Top Posters:
easytapper: 2149
DangerDuke: 2030
groinkick: 1667
PorkChopsMmm: 1515
Gravel Road: 1455
Newest Members:
Forum Stats:
Groups: 1
Forums: 12
Topics: 11482
Posts: 58640
Member Stats:
Guest Posters: 2
Members: 19842
Moderators: 0
Admins: 1
Administrators: K
